The query below can be useful for getting details for standard control and white control with versions. The query is not fully tested and serves only as a reference. Nice BlogInstall Oracle Appsr12 Dump For Better Practicewww.olx.in/item/install-oracle-appsr12-dump-at-500-only-ID1bqZlz.htm Hi Bala, Please note the following points, while entering the details in the purchase window area agreement tab (if you have selected a type of ceiling sales contract), you must choose the minimum discount for that purchase agreement line enter the agreed amount. The purchase does not automatically calculate the agreed amount on the agreed amount. You can use the agreed Amount field to provide the agreed amounts. Then enter the agreed amount. The purchase does not automatically calculate the agreed amount from the agreed amount.looks,Vidyutkumar Desai Hi Vidyut, I agree that the purchase does not automatically calculate the agreed amount from the agreed amount. But my question is that the system does not stick to the agreed minimum quantities and quantities that we are putting in the lines of the agreement. I told you one. if we had listed the agreed amount as 100 qty, and when we create a post, it allows us to create for each qty which is also over 100. So my question is that what is using the qty-barbart indication in lines, if the system allows you to crush the same thing.
Greetings, Bala. Hello friends, I have a request on the contract selling blanket. When a minimum abatement is provided under the conditions > agreement control, it remains correct and fully accepts this value for each version. But if in the PO lines, under the agreement, if I agreed on a minimum of binding, amount and amount agreed for a line, the system does not have the values mentioned here when I create a split. Zb. Creates a PO cover with a line. For the line under the Accord tab, the following values have been specified. Minimum authorization: 100.00 agreed quantity: 100 agreed quantity: 10,000 1.Si I create a release, it allowed me to create with the amount of 20.00 2.
When I created another publication for many 500, it allowed me to move forward. System didn`t stop me and didn`t give me any news of how it crossed the agreed Qty. How is it that these two cases occur 1 and 2? This goes against the agree controls for the frame line. FYI: At the header level, the minimum amount of release is good and works well. It is only for the PO line that the system does not take contractual values. Any reference in this regard would be of great help. Greetings, Bala. In fact, bpA is an agreement that you can buy any qty from the provider, but in the field of Agreed.In amount of conditions, you can give a minimum amount to limit the sharing that should not pass below that amount.
There will be an error message if you unlock larger than “agreed amount” and minimun release. Thank you Nusha.C is true if you hurt or deviate from the amount mentioned in the field of conditions. The system will send you the message immediately. I agree. But I don`t give the minimum release values in the “Conditions” field. I make available the details of the relase minutes, the agreed quantity, etc. under the tab “Agreements” at the “Blanket PO Lines” level. Greetings, Bala. An error was recorded for this problem. Please look into the metalink error number foract.
As far as I can remember, this fix is included in the 3 supply pack for 11.5.10 Hi Bala, yes, that`s true. Try to break quantitative restrictions and make sure you receive an error message.